Navigation:  Watermark >

Configuring a QRCode as a watermark

 Previous  Top  Next

To add a QRCode to be displayed as a watermark, in the section at the bottom of the desired watermark configuration, perform the following steps:

 

1.Click on the button on the side toolbar.

 

2.On the screen that will be opened, select the alignment of the item regarding the margin printing area: top, middle, bottom + left, center, right.

 

3.Then, select the QR Code option.

 

4.Enter, in the Size field, the QR Code height.

 

5.Save the record, but do not close the data screen.

 

6.In the Text item tab, click on the button on the side toolbar.

 

7.On the screen that will be displayed, select the information that will be displayed when the barcode is read in the Type field. Then, a field will be displayed to define the item according to the chosen type. For example, if the type is Fixed text, the Text field will be displayed for you to enter the sentence that will be displayed. See a detailed description of the types and items available in the Defining the information type that will be displayed through the watermark topic below.

 

8.In the Sequence field, define the item display order when the barcode is read.

 

9.Save the data. At this point, the item will be displayed in the listing of the "Text item" tab.

 

10.After performing the configurations above, save the watermark item data.

 

▪Note that it is possible to add different watermark items to different positions on the page for the same status.

▪When the file is in a status with a defined watermark, the system will display the text items concatenated in the sequence defined in the "Text item" tab. If the item is a QR Code, after reading it, the text items will also be displayed concatenated in the sequence defined in the "Text item" tab. To change the presentation order, use the "Move up" and "Move down" buttons on the side toolbar.

▪In the side toolbar of the Text item tab, the buttons to edit and delete the selected item are also available.