Navigation: Revision >

Executing the revision via workflow

When starting a new revision, if an activity must be executed in the process flow, the users set as workflow activity executors will receive the execution task.

Perform the following steps to execute the revision:

1.After the revision has been created, those responsible will receive a task for the revision of the object. To do this, go to the revision task and do the necessary changes.

The execution of the revision can also be performed through the My Tasks Activity execution task in SE Workflow.

2.Fill in all the information required in the process activity. It is possible to edit the object data. In the Revision Change section, it is possible to record the changes made to the revision.

3.Then, click on the button in the Actions sections, that corresponds to the action to be taken with the execution of the activity in question. Remembering that the required information and actions that can be performed on the activity vary depending on the configurations that are made during process modeling.

4.At this point, the flow continues to the next activity. After the responsible users for the revision steps have performed all the process activities, the object revision is terminated unless the manual shutdown for the revision has been configured. In this case, it will be necessary to execute the closing step to end the revision of the object. This step will be presented in the component revision task.

Changes may be added both by the user creating the revision and by the drafters through the draft step in the "Template revision" task.